Hi
I have a couple of buttons which changes my faders In the MIO console form Main faders to Aux faders.
I have also set a couple of presets for faders 1-4 and faders 5-8. I am on an iphone this also works great I use the send values when preset is restored.
But when I hit the aux or main button I also send a message via osc routing to a label which either says Main or Aux. Again this works fine as long as I don't change presets. When I change presets it changes the label to "main". The main button happens to be lower down the osculator document. I have been trying to use variables to set a label value but I don't think I have understood variables
Please advise
Thanks Russell
I have a couple of buttons which changes my faders In the MIO console form Main faders to Aux faders.
I have also set a couple of presets for faders 1-4 and faders 5-8. I am on an iphone this also works great I use the send values when preset is restored.
But when I hit the aux or main button I also send a message via osc routing to a label which either says Main or Aux. Again this works fine as long as I don't change presets. When I change presets it changes the label to "main". The main button happens to be lower down the osculator document. I have been trying to use variables to set a label value but I don't think I have understood variables
Please advise
Thanks Russell
Comment