User Tools

Site Tools


quickstart:start

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revisionBoth sides next revision
quickstart:start [2010/10/06 17:48] camillequickstart:start [2010/11/10 12:19] camille
Line 64: Line 64:
   - locate the message that corresponds to the particular control you want to bind and choose ''MIDI CC'' in the Event Type column ;   - locate the message that corresponds to the particular control you want to bind and choose ''MIDI CC'' in the Event Type column ;
     * for example if you want to use the Roll of the Wiimote to control MIDI CC #16, select the message "1: roll" under ''/wii/1/accel/pry'' ;     * for example if you want to use the Roll of the Wiimote to control MIDI CC #16, select the message "1: roll" under ''/wii/1/accel/pry'' ;
-  - in the Value column, choose the control change number ; +  - in the Value column, choose control change number that is not used yet 
-  - now go to the software that will receive the control changes (Ableton Live for example), and open the preference for this software.  There should be a MIDI panel where you must activate the "OSCulator Input" virtual MIDI interface ;+  - now go to the software that will receive the control changes (Ableton Live for example), and open the preference for this software.  There should be a MIDI panel where you must activate the "OSCulator Out" virtual MIDI port ;
   - depending on how the target software work, you may want to activate a MIDI learn mode((like in Live)), or manually configure the control change number((like in Traktor)).   - depending on how the target software work, you may want to activate a MIDI learn mode((like in Live)), or manually configure the control change number((like in Traktor)).
  
  
quickstart/start.txt · Last modified: 2017/01/29 09:36 by camille